HYDRO SEEDING SYSTEM
The HS-100-P, is a 100 Gallon, pull type hydroseeding system.
It has a clevis hitch and two 20 x 10.0 x 8 tires on demountable
hubs. It will seed 1300 square feet per load. It is equipped
with a 4 H. P. Honda engine that is directly coupled to a 2"
X 2" high volume centrifugal pump. The unit comes with 100' of 1
1/4" discharge hose, a gun and three nozzles ( 1 wide hydroseeding nozzle, 1 straight distance nozzle, and 1 trim
nozzle). The empty weight of the unit is 240 pounds. the loaded
weight is 1050 pounds. the physical dimensions are 27"W x 56"L x
43"H. This unit is easily pulled by a compact tractor, A.T.V. or
a utility vehicle such as the John Deere Gator.
The HS-100-P is ideal for a golf course for repairing wear
along cart paths, and for repair projects, for a cemetery, for a
school, for construction repairs such as someone installing
irrigation systems or water lines, for installing a new lawn in
areas with smaller lawns and for lawn repair and renovation . It
is capable of handling much larger jobs, but if the average job
is larger, a bigger machine should be considered. Material is
applied at approximately 30 G.P.M. Time to spray a complete tank
is about 3-4 minutes. Mixing time is 2-5 minutes depending on
material. This unit comes with 100' of discharge hose. It will
handle an extra 50' of hose. The spray distance with the
straight nozzle is approximately 40'. The spray distance with an
Area/Volume kit (2" cannon) is 60'.
Typically materials used in one load would be a half bale of
hydro seeding mulch, the appropriate amount of seed for 1300 sq.
ft. (any seed will work in hydroseeding), and the appropriate
fertilizer for 1300 square feet (liquid, water soluble, or
Like all TURBO TURF systems the HS-100-P comes equipped with
a long life poly tank that can never rust, the ability to mix
partial loads, a simple but powerful design with few moving
parts, continuous agitation, and the ability to control the flow
at the gun without making adjustments at the unit. Prices quoted
are a complete machine ready to operate. Pull type units are
intended for off road use.